We adopt a comprehensive classification method, which is divided by the ionicity of surfactants as follows which can all be provided by Insen Biotech: 1. Anionic surfactant: stearic acid, sodium dodecylbenzene sulfonate. 2. Cationic surfactant: quaternary ammonium compound. 3. Zwitterionic surfactants: lecithin, amino acid type, betaine type. 4. Non-ionic surfactants: fatty acid glycerides, fatty acid sorbitan (Span), polysorbate (Tween).
Surfactant Agent ,Carbomer 940 Powder,Surfactant Cosmetic ,Nonionic Surfactant Hunan Insen Biotech Co., Ltd , https://www.insenhealth.com
Four effective methods for increasing the output of three-cylinder dryer
The intuitive change of Zui brought by the three-cylinder dryer is that the floor space is small, but the production capacity is stronger. The new three-cylinder dryer has reduced the size of the whole body and reduced the heat dissipation area of ​​the cylinder. Zui has greatly improved the utilization of heat energy. These are important improvements that are very helpful to the enterprise. Of course, for the three-cylinder dryer Speaking, Zui should improve his production, so what are the methods to increase the output of the three-cylinder dryer? Today, let's take a look at four effective methods to increase the output of the three-cylinder dryer:
1. It is possible to install a lifting device in the three-cylinder dryer to increase the chance of contact between the material and the high-temperature hot gas. The lifting process can not be too frequent, otherwise the small-grain material will be lost with the wind, so pay attention to control the lifting device. The frequency of work, thus controlling the drying speed of the material to be dried, thus not only improving the drying efficiency, but also making the drying effect more thorough.
2. If the three-cylinder dryer wants to exert high efficiency, first of all, it must ensure the particle size of the feed. After the crushing and grinding, if the particle size of the material is not up to standard, then the drying will increase the difficulty of drying, and the bulk material In the process of raising the material, it is not easy to be fully raised, thus speeding up the feeding. Therefore, before feeding, the particle size must be small, within the range of particle size, the particle size should be reduced as much as possible, and the particle size is uniform.
3. Before entering the three-cylinder dryer, it is necessary to control the water strictly. It is necessary to go through the strict water control work, and the water that could be filtered out can not be put into the three-cylinder dryer. The waste of heat in the white is not only delayed the drying time of the material, but also seriously affects the production cost and reduces the economic benefit.